Products Description
Operation instructions:
- When using the vacuum on the pump, please remove the gas cap first, combine and release it into the container, and shorten the pipeline
- Check the air intake joint and emergency, discharge into the container and use the pipeline to seal reliably. There should be no penetration.
- Put down the exhaust cover, jam the collection device, turn on the switch, and the pump starts working.
- Turn off the pump after use, and close the pump and the valve leading to the smoke container.
- Turn off the pump and unplug the power plug.
- Remove and add pipelines
- Cover and enter the gas cap, and finally put the gas cap tightly into the cap cover to prevent dirt and stray particles from entering the pump
Notes:
- Check whether the pipeline interface swirl is consistent with the intake swirl
- Pay attention to the oil level changes during the use of the pump. When the oil level drops to the lower limit of the single-track oil level line or below 5MM of the double-track position line of the oil window, please add vacuum pump oil in time.
Work plan: - Make sure the power supply you use matches the power supply voltage and frequency listed on the product nameplate.
- Before turning on the power, make sure the pump is turned on and the switch is in the off position.
- Notes on oil in the pump
Notes:
- The rhythm is too fast, add oil. Prevent pump oil from overflowing.
- When the pump is running, the oil level should be kept within 5MM, or between the upper and lower limits of the two oil level rod lines on one oil level line. Too low oil level will reduce the performance of the pump, and too high oil level will cause oil mist to spray out.
Technical Parameters
- Fury smoking speed: 3.6 m3/h
- Ultimate pressure: 2Pa
- Electromechanical power: 150W
- Inlet connection: 1/4 inch trumpet
- Fuel volume: 150ml
- Dimensions: 255X105X202
- Weight: 4 kg